Nservo
Interface
to Any Servo Drive and
Preserve
Your Capital Investment
Nservo
Nservo
upgrades any existing system with
Retrofit
your existing system with new controls -
analog
servo amplifiers to Aerotech's
extend
the life of your capital investment
Automation
3200 32-axis motion, vision, PLC,
robotics,
and I/O platform. Nservo is a digital
Supports
2 or 4 closed-loop servo axes
2-
or 4-axis, 20 kHz sample time servo
(position
and velocity) controller. Nservo
FireWire®
enabled servo controller provides true
complements
the Automation 3200 system's
plug-and-play
wiring
series
and
networked
digital drives (Ndrive®
Npaq®
), allowing industry standard analog
Optional
Ethernet port to connect additional I/O
amplifiers
to interface to Aerotech's digital
series,
a
drive
network. As with the Ndrive®
Encoder
or resolver feedback accepted
single
plug-and-play cable communicates with
the
motion generator on the PC. A FireWire®
Connector
options include terminal block, D
communication
bus provides deterministic
connector,
and legacy OP500 connector support
behavior,
auto-identification, and easy
block
for Aerotech retrofits - reduces wiring and
software
setup from the Nmotion® SMC
changeover
time
Nservo
allows
software
controller. Other features include
upgrade
of any
limits,
E-Stop, brake, auxiliary feedback input,
existing
system using
Position
Synchronized Output (PSO) synchronizes
high-speed
latching input, and Ethernet.
analog
servo
laser
firing or other external event triggering for
amplifiers
to the
3-dimensional
machine motions
Automation
3200.
Nstep
Interface
to Any Stepper Drive and
Preserve
Your Capital Investment
Nstep
Nstep
is a one- to four-axis stepper controller
Support
up to four axes of open loop stepper
that
interfaces with any standard stepper drive
via
clock and direction inputs. Nstep can be
One
clock output (up to 25 MHz) and direction
used
in multi-axis systems where axes require
output
per axis
stepper
motor controllers that are either
sequenced
or coordinated with the servo axis
One
non-isolated digital input (5-24 VDC)
of
the system. Or it can be used as the main
controller
for a completely stepper-based
5-24
VDC opto-isolated CW/CCW/HOME and
system.
This provides the user the ability to
Drive
Enable inputs
control
all axes on the system (servo, stepper,
or
brush motor) with one motion controller -
Supply
voltage of 24 to 80 VDC
the
Automation 3200. Additionally, tighter
Nstep
allows the
integration
of all diverse axes results in less
A3200
to control any
Screw
terminal connectors for I/O
integration
work thereby shortening the
stepper
drive.
development
and deployment cycle.
Easily
connected to 3rd-party power modules